[. . . ] The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. The minimum safety distance between the cooker top and the extractor hood is 650 mm. [. . . ] Drill the support with a ø 4, 5 mm drill bit, using the drilling template provided. Cut a hole ø 125 mm in size on the support surface, using the drilling template provided. The space between the edge of the hood and the rear wall can be closed by applying the element 20 provided, using the screws supplied for this purpose. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø120 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Cut a hole ø 125 mm in any shelf that may be positioned over the hood. Fix the directional grille 8 on the recirculation air outlet using the 2 screws 12e (2, 9 x 9, 5) provided. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. When opening the sliding carriage for the first time after installing the hood, pull it out briskly until it clicks. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. [. . . ] By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ]